Inspected, found multiple leaks. Coolant and engine oil leaks detected. Cleaned all debris, found oil leak coming from top of turbo, possible turbo oil feed line. Also possible turbo drain tube leaking. There is also obvious leak from front cam actuator seals and possible oil pan. Advise customer need to start with fixing leak on top of turbo and advise severity of other oil leaks. Coolant leak coming from coolant housing on back of cylinder head, leaking down from side of engine. Need to replace coolant housing and recheck.
Replaced coolant housing rear of cylinder head, replaced hose clamps topped off coolant no visual coolant leaks present
Removed exhaust manifold heat shield found oil feed pipe loose at turbo. Tightened hold down bolt, ran vehicle, no oil pouring out of feed line. Still has leak at right cam actuator seal, fairly significant. Advise customer this will address the major leaks.
Re-sealed right cam sensor.
32front, /32 rear. Right front shows low at 26 psi. Recommend check for possible flat repair.
Alyssa B. gave our service a 5 star review on 9/26/2024
Inspected removed glow plug module harness ohm checked cylinder 6 glow plug tested open circuit, tested all others at 1.5 ohms resistance. Tested power to glow plug on cylinder 6 pulsing power as it should recommend replacing cylinder 6 glow plug and recheck. Replaced cylinder 6 glow plug cleared code road test recheck ok
INCLUDES SCANNING OF PERTINENT MODULES, RESEARCH OF CODES FOR POSSIBLE CAUSES, AND ESTIMATING TIME NEEDED TO DIAGNOSE CODES(S) Inspected pulled code p0676 glow plug control circuit cylinder 6 need time to diagnose code
https://avlink.io/l/40tsfPa
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
Light has been reset
Replaced cylinder 6 glow plug cleared codes recheck ok
Tires set to 65/75 front/rear
Wayne C. gave our service a 5 star review on 9/7/2024
Removed the old broken exhaust manifold and removed old manifold hardware and replaced with new manifold and hardware and there is no exhaust leaks at this time
Removed the old hvac blower motor and replaced with new and tested to confirm the blower motor operates as designed at this time
Removed the old rear wiper blade and replaced with new
Removed the old front brake pads and rotors and replaced with new.
Removed the rear brake pads and rotors and replaced with new
Performed brake fluid flush and added new brake fluid
Removed both the old front strut assemblies and replaced with new
Removed both of the old rear shock absorbers and replaced with new
Drained the old transmission fluid and filled with new fluid 4 quarts
Removed the old coolant over flow bottle hose and replaced with new and pressure tested cooling system to confirm there is no leaks at this time.
Drained the old engine coolant and removed both of the upper and lower radiator hoses and replaced with new and filled cooling system with new coolant.
Drained the old rear differential fluid and filled with new differential gear oil.
Drained the old transfer case fluid and filled with new gear oil.
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle. Change oil and oil filter
Rotated tires front to rear and torqued to 105ftlb
Reset maintenance light
Performed computerized alignment and set vehicle within factory specifications and test drove to confirm vehicle drives straight at this time.
Fronts 35 psi Rears 35 psi
Mary M. gave our service a 5 star review on 8/16/2024